About danny itza

danny itza · 03-26-2013

Hi all,I have been trying to make SIP calls from my Cisco 5300 RTR terminate to my ISP ( TATA) but still can’t get it to work call are getting disconnected after first Ring. Below are the equipment Involve. E0 ...

danny itza · 07-28-2011

cisco877 ----------------------Alcatel ASAM -------------------------- Cisco1941 Router "PPPoe" | | DSL GigE interface Vlan 9...

danny itza · 06-24-2011

Hi all, I am trying to set up a DHCP Ipv6 server, but when I connect my machine to the network My machine is not getting and IPv6 address neither the DNS address. If I statically configure an Ipv6 address on my machine I am able to ping my default Ga...

danny itza · 02-18-2011

Hi,I want my computer with an IPv6 Address of the block 2800:410:890:1::/64, reach both IPv4 and IPv6 address ( I don't want to use an ipv4 address on my cumputer). I configured and enable NAT_PT for IPv6 on my router. I cannot ping 2800:410:890:1::...

danny itza · 02-16-2011

Hi,I have two tunnels set up with Hurricane Electric for our IPV6 connection; the problem is that tunnel 10 is constantly dropping; this is the configuration I am using on my BGP router.ipv6 unicast-routinginterface Tunnel9 description Hurricane Elec...

danny itza · 04-27-2015

HI Vinay Sharma, we got a couple of cisco 1552E and I want to convert the to Autonomous. I downloaded the Ios from Cisco "c1520-k9w7-tar.153-3.JAB" Did the steps you mention:I configured my TFTP server on my Laptop.# debug capwap console cli XXX 2n...

danny itza · 04-27-2015

HI Vinay Sharma, we got a couple of cisco 1552E and I want to convert the to Autonomous. I downloaded the Ios from Cisco "c1520-k9w7-tar.153-3.JAB" Did the steps you mention:I configured my TFTP server on my Laptop.# debug capwap console cli XXX 2n...

danny itza · 03-28-2013

Hi Aokanlawon,Yes, calls are working without "PRACK"Below is the configuration I used but I am sure the ITSP did some changes on thier side, becuase this is the same Configuration I was using when we started the SIP Trunk connectionit never work and...

danny itza · 03-27-2013

Hi Aokanlawon,Finally the calls are Terminating succesfully. It had to do with the "PRACK" as you mensioned earlier. I called the ITSP at fisrt they were requesting the "PRACK" but then they disable that option on thier end,and they Never Informed...

danny itza · 03-26-2013

Hi Aokanlawon,I disable the " PRACK" using ( no rel1xx require "100rel") and made a TEST calls but still the calls are Disconencted.. Below is the debug cccsip messages I obtained.SIP Call messages tracing is enabledBZE-AGGR-RAS03#BZE-AGGR-RAS03#B...

Member Since	‎09-08-2010 02:25 PM
Date Last Visited	‎09-09-2020 12:48 AM
Posts	30
Total Helpful Votes Received	5

User Statistics

User Activity

SIP calls Get Disconnected after First RING!!!!!!!!!!

Problems getting an ipv6 address though PPPoE

DHCP IPv6 not Working!!

6to4 NAT-PT not working

BGP "hold time expired"

HI Vinay Sharma, we got a

HI Vinay Sharma, we got a

SIP calls Get Disconnected after First RING!!!!!!!!!!

SIP calls Get Disconnected after First RING!!!!!!!!!!

SIP calls Get Disconnected after First RING!!!!!!!!!!