About Daniel Bosch

Daniel Bosch · 02-07-2023

This bug triggered for us only because we didn't have a supervisor, agents or CSQ assigned to the "Default" team, because we don't use it. This wasn't a problem until after we upgraded to 12.5, then we started getting this alert on occasion:RTR : PO...

Daniel Bosch · 03-21-2024

Thanks, Roger.If I recall correctly, I wasn't having luck with what I found in documentation at the time. I may have been doing something wrong or was encountering a bug and didn't know it. I deposited your solution in my journal too, along with my...

Daniel Bosch · 03-21-2024

And here's an example I used with a SIP carrier. Hope this is helpful. voice translation-rule 999 rule 1 reject /2144447848/ rule 2 reject /5124651883/ <-- Calling number in this example.voice translation-profile callBlock translate calling 999 dial...

Daniel Bosch · 03-21-2024

Here's a specific example I pulled from my journal to block inbound calls on POTS lines. In my case, I translated any matching number I wanted to block to '0' since there would be no matching outbound peer. You could use any pattern that doesn't ma...

Daniel Bosch · 03-21-2024

Sorry to hear that you're in this situation. You explained things well enough that I assumed your level of expertise was a little more extensive (take this as a compliment.) If you have CUCM GUI access but can only guess if SIP or MGCP is being use...

Daniel Bosch · 03-20-2024

You betcha! Using e164-pattern-map is way better than multiple dial-peers.

Member Since	‎07-12-2011 08:09 PM
Date Last Visited	‎04-17-2024 12:04 AM
Posts	33
Total Helpful Votes Received	38

User Statistics

User Activity

CSCuy30540 - Midnight sync alert from CUIC

Re: Configure Cisco ISR 4321 to block specific incoming phone numbers

Re: Configure Cisco ISR 4321 to block specific incoming phone numbers

Re: Configure Cisco ISR 4321 to block specific incoming phone numbers

Re: 911 calls failing

Re: 911 calls failing