Is it possible to configure SIP authentication for incoming calls to CUBE? Basically I want to replicate the way CUBE uses SIP auth to place outbound calls with ITSP's, only for inbound calls.
I'm playing around with using Genie in a python script. Whenever I do anything with Genie, like device.connect(), it prints the output to the console. How do I suppress that? Thanks, Mike
I have a 3650 where remote access to the management interface is working and I can't figure out why. I configured an IP address on the management interface, but with no default route or default gateway configured, I'm able to access the switch from a...
I have a 3850 that has a multicast video encoder connected to it. I've tested playback with variety of decoders (primarily VLC player) that are connected to the same switch and the video is terrible. Multicast has been configured properly on the netw...
On a catalyst switch I have two VLANs. I have a need to configure a DHCP server on the switch for one VLAN but not the other. The issue is that on the VLAN with no DHCP server configured, the switch is still sending a DHCPNACK when it receives a DHCP...
Thanks Jeremy! That did the trick. However when I use dev.connect(log_stdout=False) then the output is not logged to a file. A few follow up questions:How did you find dev.connect(log_stdout=False) ???? I did a lot of googling and NOTHING comes up (o...
That was my next question :) I tried to create an ACL to do just that but I guess I did it wrong. Your ACL did the trick. Thanks so much for the assist @Georg Pauwen.
Mike