bijoyjackjesse
Level 1
Level 1
Member since ‎05-30-2012
‎08-26-2023

User Statistics

  • 30 Posts
  • 0 Solutions
  • 16 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

Hi Guys,The SOAP CDRonDemand Service keeps restarting every 10 min in the CM publisher. It runs a 8.x CM version. Couldn't find any Core dumps on the server. Please help me out.ThanksJesse   
Hi Guys,Hope all are doing well.I've got an issue where the when the user puts the phone on Hold - it does not Beep after a few seconds. The configuration cluster wise for Hold Reversion Timer is set to 30 Sec.. and Hold Reversion Notification is Set...
Failover is configured in the server, I'm not sure if the the Duplex was configured on the server. But when i gave the "show network eth0 detail" command, it displayed as Duplex: Auto Enabled. Now when i gave the " Show network failover" it displayed...
Hello All,I have my VG 28xx to have Slips occur in the T1 circuit(only 1 T1 for the site).Below is the controller t1 output.T1 0/0/0 is up. Applique type is Channelized T1 Cablelength is long 0db Description: PRI for Voice No alarms detected. alarm-t...
Hello,Could you guys please help me out on this one.I've got two questions.1) Could someone help me on how to find the MAC address of the 2nd NIC. the #show network eth0 shows only one or them. I get an error in the switch with the other one. (error ...
Community Statistics
Member Since ‎05-30-2012 07:39 AM
Date Last Visited ‎08-26-2023 05:15 AM
Posts 30
Helpful Votes Given To