About axeleratorcisco

axeleratorcisco · 07-10-2023

Hi,I want to start setting up a single DNAC node (without plans to converting it into a three node cluster).Following the install guide it mentions in the first part that giving the intra-cluster interface an IP address is mandatory, even though I ha...

axeleratorcisco · 06-15-2023

I have an ISE node, ready to activate it's license. I read that syncing with CSSM will in basis send license status information, but also things like hostname, ip address and mac address to CSSM.Is there a possibility to turn off sending this additio...

axeleratorcisco · 06-12-2023

Hi,I am looking to temporarily have my ise nodes activate their license via a proxy.Is it required to do this using an ad account via basic authentication? (I read it only supports basic authentication)Or can you leave this out and just have the ise ...

axeleratorcisco · 04-13-2023

I have installed the SSM On-Prem 8 202212 ISO. I chose the DISA STIG profile instead of the default one.After booting up, i can SSH into the machine. However, the Web GUI isn't accessible. The firewall is allowing the traffic.I am using the https://i...

axeleratorcisco · 03-14-2023

I just tried a "reset-config" on a ISE 3615 physical server, to change the default domain name. It is a standalone node ready to be tested, so no impact on any services. It promises me the following:isedemo/admin# reset-config% WARNING: This option w...

axeleratorcisco · 09-18-2023

I have the exact same question.Is a client blocked permanently after 3 attempts?If not permanently, then for how long exactly?How do you restore access for that specific client again?I know about the existence of the login block-for command, but i am...

axeleratorcisco · 08-21-2023

Looking for a similar setup.I have a Catalyst switch which I want to connect redundantly to two Nexus switches. The Nexus switches connect to a firewall cluster.Is it possible to create an L3 port channel on the catalyst, a L2 VPC on the Nexus side, ...

axeleratorcisco · 07-10-2023

An additional question:I am used to assigning a FQDN to each interface, but I understand that DNAC is only capable of assigning one FQDN for the entire box? Is this correct?Which is typically used? As I understand it's normally the VIP address, but I...

axeleratorcisco · 06-20-2023

No one any idea?

axeleratorcisco · 06-12-2023

3.1Yes i want ise to use an internal proxy to reach cssm.Can i just fill in the ip address/port of the proxy?Or am i also required to fill in the username/password in ise to authenticate to our proxy?E.g. MUST we use "basic authentication" on our pro...

Member Since	‎02-23-2012 08:01 AM
Date Last Visited	‎09-25-2023 12:57 AM
Posts	83

User Statistics

User Activity

DNA center standalone setup

Smart Licensing - mac address, hostname and IP address sync

Cisco ise smart licensing via proxy

SSM On-Prem - Web GUI not working after install, SSH is working

ISE reset-config system certificates

Re: ip ssh authentication-retries

Re: Portchannel one side L3 interface and other side L2 interface

Re: DNA center standalone setup

Re: Smart Licensing - mac address, hostname and IP address sync

Re: Cisco ise smart licensing via proxy