Hi,For this card there will not be any t3/e3 controller rather a serial interface would get created. Check for serial3/0 or 0/3 depending on where the module is inserted. That would be your T3 interface on which you need to put IP address , service-p...
Kuldeep,Have you even read what people have commented on your query rather than just blindly putting some redudandant posts? What is it that i've wirtten in my post not clear to you or not applied in your scenario? What is the setup? Please follow th...
Kuldeep,You're running PPP on layer 2 and the " "F0/1 is up, line protocol is down" says the layer 1 is fine and layer 2 (which is PPP in your case as per your notes) is not being established. In this case, you don't need to run any of the Frame rela...
'show interface serial' on r1 if shows line protocol as down then you should get the idea that something is not right on the other side. Other than that you can run debugs to check for the status of the other. what is the encapsulation you've on both...