we will change ip address of TMS what i have to do after change the server which TMS install on it, and for the TMSXE how i can change the TMS old ip address on TMSXE server.
i have new BE6K start to install CUCM frist node PUB then power of before finished installion after configure network (ip of device )i removed it then by OVA start installation again but i couldn't its give this errorinstallation failed restart inst...
i have ATA configure in CUCM 8.5 there was old fax machine was work no issueswhen i get new fax machine HP LaserJet MFP M880z it can send fax but not able to receive fax it's give error when fax come to itnotes old one work if i connected it can send...
hi Robertoyou can do Hyprid doployment with spark, and you will be able to call from and to spark using URL for endpoint register on spark and if your countiry allowed you will be able to use on promissis voice gateway for PSTN calls from spark too.k...
Hiromichi Kawanobei have uc520 its not supported cp-6921 i thank its need upgaredwhat is the steps its same like CME router only change boot image or there is anther way for this plz advise
thanksi already understand now how to do it with h323 by using different RP with different prefix then match it with dial peer in VGfor the sip lines come from service provider connected to my VG router what i needin CUCM i need to configure sip tru...
hi robertssean i'm not apply my lab yet but i thank first the phone was worked before? if yes what is the last thing happend second CME or SRST version must be 4.1 4.2 4.3 and later minimum 12.4(15)t7be sure you can ping from CME to APbe sure voice v...
