Hi Eugene, Try to log in as admin using ssh/console and execute following command: xConfiguration Video Wallpaper: Summersky Best regards,Sergey Kuzmin
Hi Ondrej, I've just checked MX200 with software TC6.2 and do not see any process which might listen port 857/UDP.I'd recommend you check endpoint to make sure that NMAP is telling truth. Log into endpoint using ssh and root credentials. The followin...
Hi Svetoslav, At the moment you have at least to solutions:1. Buy and use VCS Expressway. You will be able to register endpoints from branch offices (other towns) on you VCSE or VCSC (using SIP proxy registration) and place calls outside your network...
Hi Svetoslav,The only solution, I see, is to configure VPN tunnel (IPsec, GRE) between ASA firewalls and configure routing between subnets 192.168.100.x, 10.1.1.x and E20 subnet. After that E20 will be able to register on VCS control.Best regards,Ser...
Hi Oleksandr,The part numbers and ordering information you can find in the following document, section "Ordering Information"http://www.cisco.com/en/US/prod/collateral/ps7060/ps11305/ps11315/ps11337/data_sheet_c78-697073.pdfCisco TelePresence Video C...