About ksherwood

ksherwood · 09-27-2021

Can anyone please give me the power consumption of any C9500 and C9300 switches. Also, Cisco ISR 4331/K9Cisco ENCS 5412 I know there are lots of models but I'm looking for a rough idle figure.The Max power spec isn't realistic for this purpose.

ksherwood · 07-09-2020

Can anyone suggest how you would mirror the logs of your switch without turning on both TX and RX (so not to generate duplicate entries) ?I am monitoring RX packets which doesn't include the local switch logs, which I want to capture also !

ksherwood · 03-16-2018

Hi, router configured with PIM stops streaming after several minutes. Access switch has client connected. Can anyone suggest some common reasons why this may happen ? Thanks

ksherwood · 10-25-2016

I can PING and HTTPS into my APIC but can't SSH ??? Does anyone know why this might be the case ?

ksherwood · 10-15-2016

Hi, a quick question: Once a layer two out connection has been made with the required elements including the EPG, when you set up a leaf port for a test node connection, does this EPG need to be a new one which only tags the single vlan required ? ie...

ksherwood · 09-28-2021

Hi Georg, sure, but I am after some rough figure, and not the Max power. I'm hoping someone out there has measured the power draw for similar reasons of my own. Cisco ISR 4331/K9Cisco 9300 24Y4CCisco 9500 24Y4CCisco ENCS 5412

ksherwood · 09-28-2021

Thanks Marce, I did find the C9300 running values but unfortunately they didn't do the same testing for the C9500.That table 1 doesn't give actual power figures. Kevin.

ksherwood · 07-13-2020

Ok, I have worked it out.All you have to do is create two layer three interfaces (or switch virtual interfaces) and connect them together.The RX monitor interface is one of them and the same interface is the set as the 'logging source interface'.Mak...

ksherwood · 03-16-2018

Hi Nipun, I know the detail is sometimes important but I really don't want to answer lots of questions. I am asking for common reasons for multicast traffic to works initially and then to stop after a few minutes. I noticed that it was using incomi...

ksherwood · 11-03-2016

I was always just using the default access policy. Now I can SSH directly to my only APIC but not to any other switch...is this normal ?

Member Since	‎04-25-2007 03:51 PM
Date Last Visited	‎05-16-2022 02:39 PM
Posts	88

User Statistics

User Activity

C9500 and C9300 Power consumption

How to mirror switch logs

Multicast traffic stops flowing after several minutes

SSH into APIC

ACI test node

Re: C9500 and C9300 Power consumption

Re: C9500 and C9300 Power consumption

Re: How to mirror switch logs

Re: Multicast traffic stops flowing after several minutes

Thanks Tom, I actually wanted