Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,On old nx-os like 7.0(8)N1(1) local admin users were not able to login to the device when tacacs+ is working. This behavior seems to have changed on newer version like 9.3.10 and 10.2.4 for examples. Indeed, with same configuration than older vers...
Hi we are facing a memory issue and the bootflash: is totally full. Therefore the ISR4331 running on version 16.12.6 is rebooting in a loop. From rommon I'm not able to clean flash: as there isn't any commany "del" "delete" "erase" "format" or even ...
Hello all, What parameters on a Cisco firewall FPR2140 connected in 10g (and I would say a firewall in general) could explain why a TCP flow is limited to between 370 and 430Mb/s while different test with iPerf showed the following :- 1 TCP flow : ma...
Hello all, I'm trying to configure Layer3 subinterfaces on port-channel on a C9500-48Y4C with version 16.9.4. However it seems the feature is not enabled or supported. When I try to apply this interface Port-channel10.3000encapsulation dot1Q 3000ip a...
HiI configured flexible netflow on cat6k with sup2t and I was wondering whether eigrp is considered as flows ? Actually I configured netflow on an interface that is part of a p2p link where EIGRP is running. I'm a bit surprised to not get the eigrp h...
HiI might have not been clear enough in the description. As mentioned the "local" keyword allow me to run all command for local user. My issue is that the local user can authenticate on the device when tacacs is working. When tacacs is well working t...
HiIn my case this was an hardware issue that caused the looping reboot. RMA, no other choice. However in ROMMON the command to remove any file doesn't exist anymore.
Hi, thanks for your replies but to answer posts that suggest to delete files, again, this is the topic here : I can't delete anything because : 1. I'm not able to boot the IOS2. I'm in ROMMON3. There isn't any command in the ROMMON to delete anything...
