Hello, There is one question to community:Where we can setup preferable codec in Cisco SIP dialer?It is needed to change g711ulaw which is default SIP Dialer codec to g711alaw. Thanks in advance,Regards,Alex
Hi all.There are cluster CUCM 7.1.3. and three AS 5350.(SIP)In our cluster is one default Region with g711 codec. All inbound and outbound calls pass excellent.But it is a problem with recorder server (ZOOM). There are 1-2 calls per day which are not...
Hi all,please help with next question:How I can transfer answer from PSTN provider to IP phone through H323 Voice gateway.CUCM 7.Answer from PSTN provider like "subscriber is busy" "this number is not in service" etc.I thought it needed check Enable ...
Hi,We going to upgrade our CUCM cluster (3 Nodes). From Version 7.1.3.10000-11 to 7.1.5.34900-7.I know that CUCM requires 72 Gb free space at installation.But I afraid of upgrade. How does to increase disk usage after upgrade??Now we have one HDD (7...
Good day!We have done this recommendations for Windows 2003 SP2 servers and had a problem.After disable TCP/IP Offload (IPv4 Checksum Offload) we cannot access to RoggerA through RDP.Also we cannot hear port 3389 to RoggerA.After our investigation we...
Hi Mike,Сan I guess that 200kb/s will be enough for only audio g711 call?Could you say approximate date when new documents will issued?However we installed yesterday JG on our lab environment. It works fine. And it's really easy to configure it.Thank...
Thanks for link Amit.If to be more precise I'm interest in requirements to bandwith between Internet client and Expressway-E.Regarding this explanation http://blog.cdw.com/product-review-cisco-jabber-guest/#comment-267246it's step 1 and 9.Regards,Ale...
Chintan, I see that INVITE from dialer comes with one codec g711ulaw. Please see below:INVITE sip:0675498693@10.13.81.27 SIP/2.0Via: SIP/2.0/UDP 10.13.81.3:58800;branch=z9hG4bK-d8754z-57145a04a377e42c-1---d8754z-;rportMax-Forwards: 70Require: 100relC...
Hi Chintain,thanks for response.Yes it's right we can create settings on dialpeers, but I don't have any dsp resources and PSTN provider accept only g711alaw. So I am try to find way how to change default SIP dialer codec from g711ulaw to g711alaw. r...
