Hi to all
I have to configure anyconnect from the guest-wlan with external dns-servers configured. NAT is needed to translate the public ip addresse of the firewall outside interface to the private ip adress of the firewall-interface terminating the ...
HiWhat is the problem when all the ikev2 vpns are showing lots of #pkts invalid len (rcv) with sh crypto ipsec sa detail?
Crypto map tag: peerX, seq num: 100, local addr: 213.221.227.114 access-list S2S_VPN_JOKER_IT_AZURE extended permit ip 1...
HiI have migrated the configuration from a C170 to an ESAv C100v same versions in both 11.0.4-003. Everything is working fine including virus and other updates, but if i try to update to a newer OS version I get the message "No available upgrades."VL...
HiI have three switches WS-C2960S-FPS-L with IOS 12.2(55)SE6, which I would like to upgrade to 15.0(2)SE6. Switch is in reboot cycle after starting with new IOS....done Initializing flashfs.Checking for Bootloader upgrade..Boot Loader upgrade not req...
CME 4.1(0) and IOS 12.4(15)T1 on 2851.Also tried with CME 4.2 and 12.4(11)XW1, same problem.Call Transfer with full-consult is not working with internal or external calls.If I configured full-consult, I can consultate the second DN (now original call...
Hi Filipdid you found a solution for this problem, or are shared lines not supported with CSTA. I have same problem a CTI solution XPhone Express using CSTA.
RegardsPeter
HelloCould you solve this issue. It looks like Bug CSCur09885
Description
Upon VSS-standby reload, the route entries corresponding the L2 Multichassis Ether Channel are not installed at VSS-standby. Partial packet drops are observed. Symptom: For IP...
HiDid ypu find a solution to your problem? I have exactly the same problem with some switches. I think it has something to do with bootloader upgrading not working or not done with some older model revision numbers of the 2960S switches. See also my ...
