Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am getting the following error message when trying to apply a domain profile to a set of FIs? I am not configuring a DJL2.Validate Port PolicyVLANS 10,11,100-101 from ethernet group allowed vlans(10,11,100-101) are not part of the allowed dis...
We currently have 2 10G FC connections going into each FI and a pair of Nexus 5K's (a total of 4 10G connections). This consists of our vPC and it is displaying an operational speed of 10G, should this not be 20G?
After upgrading to 2.1(1b) I noticed a new entry when creating your dynamic vNIC's/templates (see attached pic). How is this different from the previous implementation of the firmware?Thanks
I have the typical setup:2 x 6248 Interconnects2 x Brocade SAN SwitchesEMC StorageAll cross connected for redundancy. However, I am not seeing any logins to the second SAN switch when I boot a blade. I looked at all the vSAN config's etc., and it loo...
Yes, I have been using VMQ for years now. The Cisco docs are horrible to find anything in one place and usually doesn't give a straight answer. To that end, you should look for some additional tuning references for VMQ on Cisco UCS on the VBlock/VxBl...
I would definitely move to smart zoning as it saves a few steps when zoning 1 initiator to 1 target. Are you only using 1 vsan? Another way to organize this is one vsan per array? So if you have 3 disk arrays, you would have 3 vsan's per fabric. This...
This is now fixed in 2.2(4b) with R2..... Among other enhancements..... http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/release/notes/ucs_2_2_rn.html
I have seen the VMQ limit being reached when applying the VMQ policy to the vNIC template. Can you try not selecting the VMQ policy for these new vNICs. If this works, you might be reaching the VMQ limits as described below:Number of VMQ's:128 is the...
