What are some recommended RF Profiles for a high density layout using AIR2602i APs.

Attached is "Figure 1" which depics a worst case but working multi-vlan configuration which includes the use of the "native vlan" 240 at each point.This works with version 7.035.3 and older covering the last 3 years of use. Here we turn on "VLAN Tran...

Anyone know where or how to get information/instruction to map a Windows network drive to my virtual NCS box so I can access reports and preload firmware?

I am using a 3560 on Root-Bridge side and a Cisco 2960 on the Workgroup Bridge side. Cannot migrate Vlan info to 2960 switch, thus cannot re-assign switchport access on a port to any VLAN other than the Native VLAN. Any way to make this happen withou...

We have a detached building to bridge to. Using the latest JA2 software, configured the A-Radio on the WLAN side as a root bridge, and in the detached building the A-Radio as a non-root bridge. A Cisco 3500 switch resides at both ends connected via B...