About Gordon Charlton

Gordon Charlton · 10-18-2016

Hi, I wonder if someone can point me the right direction to configure a DSP Farm for an ISR4331 I am setting up for CME. The command I would have used under the voice card on a G2 is longer supported. I realise they G3 cards have on-board DSP's, b...

Gordon Charlton · 12-15-2011

We have a new UCS C200 M2 server that is running ESXi 5.0.0 and will only neg a speed of 100MB - tried connecting it to a GLC-T on a 3750 and also Copper Port on 2960G - same result.Trying to hard set speed to 1000 in vSphere Client produces an error...

Gordon Charlton · 07-06-2009

Hi,Has anyone tried to configure a WIP310 for use with a UC520? I'd have guessed it should be possible to at least use it as a "third party" sip client?Any help/advice would be great!Regards,Gordon

Gordon Charlton · 10-18-2016

Hi Manish, Thanks for this, however, in this case I have a BRI interface, not PRI. I can enter: voice-card 0/1 (the BRI card) But the DSP command is not available. Regards, Gordon

Gordon Charlton · 01-15-2016

From what I have found you need to create a custom cptone with the following settings: TONE FREQUENCY in Hz CADENCE in seconds Acceptance tone 400+450 ...

Gordon Charlton · 07-03-2015

We have been working on a deployment using Meraki AP's and were consistently seeing phones un-registering to CME when trying to make a call.On the back of this document we changed to 5GHz from 2.4GHz and the issue appears to be resolved!Many thanks f...

Gordon Charlton · 05-07-2015

Hi Frank, I have just resolved this issue by adding the following permissions to the user:Standard CTI Secure ConnectionStandard CTI Allow Control of All DevicesStandard CTI Allow Control of Phones supporting Connected Xfer and confWe are running CUC...

Gordon Charlton · 04-01-2013

Hi Matt,Thanks for your post - we had the same issue. Upgraded CUCM from 8.5.1 to 8.6.2.Re-installed the new version of TSP and switched to Media Driver, instead of WAVE driver (a working config we had on another system). CTI Ports registered, but ...

Member Since	‎06-02-2009 10:17 AM
Date Last Visited	‎10-09-2017 11:48 AM
Posts	11
Total Helpful Votes Received	25

User Statistics

User Activity

Configuration of DSP Farm on ISRG3 (ISR4331)

UCS C200 M2 R200-1120402W Nic will only negotiate 100MB Full

UC520 WIP310 - Has anyone configured WIP310 for UC520 or CME?

Hi Manish,

From what I have found you

We have been working on a

Hi Frank, I have just

CUCM 8.6 and TSP 32 bit