If anyone else runs into this you will need to contact TAC to apply the workaround. Otherwise, updat...

Thanks @Jaime Valencia! I have MFT setup now and it works with offsite clients.

We are using openssh v8.x and ran into this bug. Does anyone know if the workaround command is run f...

No, I do not have MFT configured or I assume it is not. I will check out the guide on this. Thanks!

I have MRA 12.5.7 and external users cannot post screen clippings in chat. I have read were this is ...

Didn't think of that. That's what I like about multiple ways of getting things done with CM. So I ju...

Good question. This is a 2911 gateway that I have setup as a SIP trunk currently for the FXS and T1 ...

That's what I was afraid of. I may just end up putting in a wireless phone such as the 8821. This is...

I should also mention that the SIP trunk that the call is coming in on is not the same SIP trunk tha...

Is it possible to route a call to both an internal ip phone registered with call manager and also ri...

@Rob Ingram . Sorry I meant DH groups typo. That was the issue. Once I enabled the supported DH grou...

Hi @Rob Ingram Ok, thanks. It will not allow me to connect to the ASA with 4.9 but I assume this is ...

Is anyconnect 4.9 supported on an ASA-5516x? According to the release notes it states:ASA Requiremen...