About vyas.nilay

vyas.nilay · 04-08-2021

I have a connection to Microsoft Azure via Megaport. Megaport asked me a question if my device i.e. 3850 is capable of QnQ tunneling and I know it is capable of QnQ tunneling. My inner vlan 901Outer Vlan 999 Switch : 3850it holds the L3 configuratio...

vyas.nilay · 04-08-2021

Topology LAN AS 11(192.168.x.x) ---- DMZ AS 12 |------- MPLS 13 (172.16.x.x) |------- MPLS 14 ( 10.x.x.x) LAN AS 21 (192.168.x.x) ---- WAN AS 22 |------- MPL...

vyas.nilay · 02-15-2021

Hi, Need a help. User --- ROUTER -- SERVER User 10.1.1.10router 10.1.1.1server 203.152.100.32 9400 I am trying to setup a NAT where user is trying to access the server on port 9400 but it is using router inside IP address as server IP address.I have ...

vyas.nilay · 10-19-2020

Hi, My internet router interface is getting lot of flush and input errors. There is no drops and bandwdith is not reaching to the max which is 500 Mbps. Can anyone please guide me the way forward? GigabitEthernet0/2 is up, line protocol is upMTU 1500...

vyas.nilay · 06-16-2020

Please help.. I am trying to troubleshoot an a possible issue with DHCP. I have setup my IP SLA but it is only 50% success and keep on failing with Over threshold. I am not too good with IP SLA so I might be missing someinformations. RTT is too hig...

vyas.nilay · 02-16-2021

Sorry guys I do understand Running configuration and proper diagram would be great but I can't due to restrications.User has to connect to the proxy server which is behind GRE tunnel.Very simple way to explain,User can only connect to the Zone which ...

vyas.nilay · 10-21-2020

I found a WS-C3850-24T.. external DMZ in the network.. I will create interent VRF and terminate the connection on that switch. I think this should do the trick. Thank you every one for your help and support. Nilay Vyas.

vyas.nilay · 06-17-2020

Sure I will make it 15000 as Threshold to see what happens.. Is there any way to log over the threshold respond?? as I can leave it and check if goes over the threshold. Thanks,Nilay.

vyas.nilay · 09-10-2019

Hi, no routing is not enable. However the switch management is address is in vlan 8 - 192.168.8.250Collector is connected to same switch on port 28 with IP - 192.168.8.110default gateway of the switch is 192.168.8.1 Thanks,Nilay

vyas.nilay · 09-09-2019

It is two switch stack with same model and liceces.

Member Since	‎01-19-2007 12:31 PM
Date Last Visited	‎04-09-2021 07:35 AM
Posts	61
Total Helpful Votes Received	6

User Statistics

User Activity

Azure QnQ tunnel qustion

BGP Aggregate Address question

NATing help for ASR rotuer

Input errors and Flush errors

IP SLA DHCP keep on failing

Re: NATing help for ASR rotuer

Re: Input errors and Flush errors

Re: IP SLA DHCP keep on failing

Re: Netflow lite issue

Re: Netflow lite issue