Hi all,I cannot seem to get Native IPv4 Multicast PIM-Joins to be mapped to an mLDP LSP on IOS-XR 4.3.2. Is this even supported on IOS-XR 4.2.3? Thanks,DL
Hi All,Does anyone know if label mapping messages from mLDP can use ISIS Address-family ipv4 multicast for RPF? I know regular PIM message can use it for RPF but am not sure about mLDP label mapping messages.Thanks,DL
Hi All,I've combed through reference and config guides but cannot find documents pertaining to the following command under isis:nsf advertise-holdtimeDoes anyone know exactly what this does?Thanks
Hi Harold,I was trying to see if I could signal an RSVP-TE LSP originating from a regional customer carrier towards a VRF interface of a Carrier's Carrier PE1 and then out of the VRF interface of the Carrier's Carrier PE2 on the other side, then down...
Giuseppe,What if I have 3 routers, A, B, and C. Router C sends an ARP request for a destination to Routers A and B. Router A sends an ARP reply to C for a specific route, but Router B later sends an ARP reply to C for a 0.0.0.0 route. Which ARP en...