About alexis.katsavras

alexis.katsavras · 08-09-2016

Hi there, I have a few DX80 register with CUCM and setup for Extension Mobility When a user log's into the DX with his EM profile for the first time he gets asked to setup allot of things like webex, contacts etc. If he logs outs and logs back in o...

alexis.katsavras · 05-20-2016

Hi there, I have CUCM-BE running on a BE6000M. The CUBE is also running on this device and the device is in the DMZ. So set-up is: CUBE <---DMZ--->F5 firewall <----> ITSP Note: CUBE is on a private IP address and only one interface is been used Th...

alexis.katsavras · 06-17-2015

Hi there,On the RTMT there is a pre-configure alert called HardwareFailure. The description of this alert states:"This alert occurs when the HardwareFailure event is generated. This indicates that hardware failure event (disk drive failures, power su...

alexis.katsavras · 05-08-2015

Hi there, I have the following call flow set-up:CUCM 10.5 <==> SIP <==> CUBE 15.3 <==> SIP <==> Telco Incoming calls work fine.Outgoing calls to mobile only are failing. When the call is made the mobile phone will ring but one's its answered the cal...

alexis.katsavras · 03-12-2015

Hi there,Was wondering if someone could point me in the right direction on this as I am fairly new to the security field.I would like to only allow IPSEC connections through one of the public IP address on the ASA (ver 8.2(5)) outside interface. NAT ...

alexis.katsavras · 08-10-2016

OK thanks for your input Dennis alexis

alexis.katsavras · 05-19-2015

Found the resolution to this. Change made under the SIP Profile for the SIP Trunk

alexis.katsavras · 05-08-2015

Thanks for the help Adeolu .. took a while to actualy get round to implementing it. alexis

Yes i did. For me this worked · 03-13-2015

Yes i did. For me this worked.On CUCM cluster A I untick "Home Cluster" and untick "Enable User for Unified CM IM and Presence".I waited for 24 hours for the CUPC clusters to synch (or you can force a synch)Then i was able on Cluster B to declare th...

alexis.katsavras · 01-29-2014

Thanks Aaron. Worked like you decribed cheersAlexishttp://www.netpacket.co.uk/ http://www.blog.netpacket.co.uk/

Member Since	‎11-24-2009 01:59 AM
Date Last Visited	‎10-09-2017 11:56 AM
Posts	93
Total Helpful Votes Received	10

User Statistics

User Activity

DX80 with Extention mobility

NAT SDP Packets within CUBE

Reporting on Hardware status using AXL

Possible codec issue on CUBE

Allowing an IPSEC conn through and NAT it

OK thanks for your input

Found the resolution to this

Thanks for the help Adeolu ..

Yes i did. For me this worked

Download scripts, prompts and documents from UCCX 8.0.2