About bmcginn

bmcginn · 09-01-2014

Hi,When you say that you can ping 192.168.1.2 from your personal laptop, where is that laptop connec...

bmcginn · 04-27-2014

Check to ensure the switch doesn't have any q-in-q tunneling going on. If the other end of the l2tun...

bmcginn · 11-20-2013

Hi there,Try adding the enable line in.eg aaa authentication enable default group radius enableRegar...

bmcginn · 04-29-2013

Hi Mohammed,You'll need to provide more information. Is it a router? is it a switch? is it an access...

bmcginn · 04-29-2013

Hi Andrew,You can also look at NBAR by matching the ICA protocol directly. I've looked at a 2821 run...

bmcginn · 01-07-2013

Thanks Ajay.I appreciate yourr help and time.Brad

bmcginn · 01-06-2013

Hello Ajay,Thanks a lot for the reply, it's very helpful. At the moment, there isn't any NATting pre...

bmcginn · 01-03-2013

Hi All,I've a quick question about bridged mode in an ACE module.Is it possible to have the servers ...

bmcginn · 05-28-2012

Hi Rizwanr74,That was it, thanks for the reply and the help!Brad

bmcginn · 05-28-2012

Hi jennifer, routing was the key, specifically the router mentioned below by rizwanr74.Thanks!

bmcginn · 05-27-2012

Hi all,I've run into an issue and I'm hoping one (or more!) of you have seen this before.I've config...

bmcginn · 06-28-2011

Hi there,What you've got there looks pretty fine. The below configuration will work. A few things yo...

bmcginn · 05-30-2011

Hi,There was a FWSM in that device and it was playing up. I've had it RMA'd and will be installing t...

bmcginn · 05-30-2011

To get this working I ended up doing:Deleting the chassis from the ANM from the Config->Guided Setup...

bmcginn · 05-17-2011

I'll be blowed, that document proves I am wrong. The 2960 I'm trying to get it to work on must be a ...

Date Registered	‎12-12-2007 10:36 PM
Date Last Visited	‎10-11-2020 10:53 AM
Total Messages Posted	204
Total Helpful Votes Received	95

Hi,When you say that you can