About bmcginn

bmcginn · 01-03-2013

Hi All,I've a quick question about bridged mode in an ACE module.Is it possible to have the servers on a separate subnet rather than on a directly connected VLAN? Due to limitations brought on by physical aspects of the setup (and also security poli...

bmcginn · 05-27-2012

Hi all,I've run into an issue and I'm hoping one (or more!) of you have seen this before.I've configured an ASA5505 to be Lan to Lan VPN tunnel endpoint, peering with a linux box. The ASA is full licensed so that side isn't an issue.PROBLEM:When th...

bmcginn · 05-15-2011

Hi all,When configuring the ANM to import 6500 chassis' and ACE modules, I used an account whose password needs to be changed every so often.I've looked for a way to change the password in the ANM for this account however I can't seem to find where t...

bmcginn · 05-04-2011

HI all,I have a 6506-E here that randonly drops packets and I'm trying to find out why.When debugging ip packets (debug ip packet 52), I found a whole lot of these:May 4 22:42:14: pak 5007BF54 consumed in input feature , packet consumed, MCI Check(5...

bmcginn · 02-24-2011

Hi all,I'm hoping some of you helpful people on this forum can guide me or suggest a solution to a problem I'm faced with.I am currently load balancing exchange 2010 traffic via an ACE module. Software version is A2(3.3). I have most parts of it wo...

bmcginn · 09-01-2014

Hi,When you say that you can ping 192.168.1.2 from your personal laptop, where is that laptop connected? In the 192.168.1.0/24 network or the 192.168.2.0/24?I assume you're not trying to route traffic between the 819 and the E1200 and you just want ...

bmcginn · 04-27-2014

Check to ensure the switch doesn't have any q-in-q tunneling going on. If the other end of the l2tunnel has it's duplex out you'll see the message on this end as CDP is tunneled through the switch.R2(HD)-----(FD) SW (FD)------R1(FD) ...

bmcginn · 11-20-2013

Hi there,Try adding the enable line in.eg aaa authentication enable default group radius enableRegards,Brad

bmcginn · 04-29-2013

Hi Mohammed,You'll need to provide more information. Is it a router? is it a switch? is it an access-point? What model and IOS?Without the above it is difficult for forum members to help.You may be able to try something like:show int | i is up|inpu...

bmcginn · 04-29-2013

Hi Andrew,You can also look at NBAR by matching the ICA protocol directly. I've looked at a 2821 running 12.4(25f) to get this config.Something like: class-map citrix match protocol citrix!policy-map citrix-map class citrix bandwidth 128 cla...

Member Since	‎12-12-2007 10:36 PM
Date Last Visited	‎07-29-2021 07:54 PM
Posts	204
Total Helpful Votes Received	96

User Statistics

User Activity

ACE bridged mode

VPN not initialising.. ASA 5505

Application Network Manager 4.1(0)

6506-E randomly not forwarding packets

ACE module SSL url rewrite and path rewrite

Hi,When you say that you can

Check to ensure the switch

Password Required but None Set (ssh)

High link utilization

Quality of Service (QoS) mapping