Hi all, Kindly need your helpcurrently, I have set up clustered expressway edge for Jabber MRA as below cluster1.domain.comedge1.domain.comedge2.domain.comedge3.domain.com My question isIf I use FQDN of Cluster as Common Name do I need to generate th...
Hi All,
We currently planning to migrate phone from CUCM cluster 9.1.2 to CUCM cluster 10.5.2 and we will do the migration per-site.
Current condition we found on CUCM 9.1.2 that callmanager.pem expired since 1998 and TVS.pem expired since 1999. ...
Hi Folks, kindly need your help I've problem with BE3000 while setting SIP Trunk
Summary: Summary : Currently we have Cisco BE3000 with software version 8.6.4.10000-15. We need to perform PoC to integrate BE3000 with Panasonic NS300 using SIP Trunk. ...
Hi All,Kindly need your help, I've experiencing an error on Unified Presence 8.6.5. On Diagnostic > System Troubleshooter there is an error says " Cisco UP Replication Watcher has detected that database replication is still in progress ". Did you ha...
Hi All,Kindly need your help. I was trying to built Remote Access VPN connection on my lab environment. The component is Router 2811 with (c2800nm-advsecurityk9-mz.124-22.T5.bin), Anyconnect Client ( anyconnect-win-3.1.05160-k9.pkg ), Laptop ( Firewa...
Hi Roger, So I just need to generate the CSR from master node and upload on each node in the cluster that should work? Because I worried that the private key from each node is different then if I only generate CSR from master node and get sign from...
Hi Bro,If you use putty AFAIK, then what you need to setup is the serial Line and baud speed.Have you try to check what COM Line that active on your computer (you can check on the control panel > device manager). The baud speed itself I setup to 9600...
Well, from this point you can ping 10.10.3.236.1. What protocol that you use to access the server ? If I see the way you access, you are going to open shared folder? correct me if I'm wrong2. Can you just use ip address to access the server ?3. Is th...
Yes it was about replication issue. I found that replication on all node is 2 which is indicating in good state. Actually I found that some data in publisher and subscriber is not match. My solution is I try to utils dbreplication repair node to repa...
.jpg "VIP Expert"){kind=icon}
.jpg "Hall of Fame Master"){kind=icon}
