About Simen Ringstad

Simen Ringstad · 02-09-2017

Hi,We upgraded our ISE from 2.1 to 2.2 yesterday. Up until the upgrade sending guest credentials using the SMS HTTP API worked fine. After the upgrade it no longer works. There is nothing wrong with the http-string as it works when I try from my brow...

Simen Ringstad · 02-10-2016

Hi, I am working on getting our ISE device administration working and have hit a snag. I am trying to only let users of certain Active Directory groups authenticate. I have configured Authorization policies with AD-groups and it works fine. It's the ...

Simen Ringstad · 10-03-2013

I'm having problems with the 12.2(55)SE7 software when using Tacacs. It seems the CPU load is so high I am not able to log on to the switch. When I change the config, via SNMP, to use local userdatabase I can log on, but the CPU load is still very hi...

Simen Ringstad · 08-19-2013

Hi everyone,I'm trying to build a config file for factory default switches to pull from a TFTP server. The switches are at remote locations with a managed wan-connection where we have no control over the directly connected router. The config files wo...

Simen Ringstad · 12-05-2012

We are about to a large amount of access points from access ports to trunks. Is there a report function in NCS that will give me a list of the APs and their CDP neighbor? I am able to view the information under "monitor/devices/access points" but I c...

Simen Ringstad · 02-15-2016

Thank you for your clarification, Jatin! Sounds like I have to come up with a new approach.

Simen Ringstad · 01-03-2014

The directory for the TFTP server is /tftpboot/*NOTE* This is not the directory LMS use when deploying software - only when you use LMS as a TFTP server - eg copy tftp flash on switches.

Simen Ringstad · 10-28-2013

That helped tremendously!Thanks, Luke/Richard.. Best regardsSimen Ringstad

Simen Ringstad · 10-17-2013

Thx for the info!I wanted to filter out interface up/down messages sent to our Cisco Prime syslog and used the following commands to make it happen.logging discriminator linkud mnemonics drops UPDOWNlogging host "IP of syslogserver" discriminator lin...

Simen Ringstad · 09-24-2013

Routers use layer 3 addressing to make routing decisions. VLAN ID is a layer 2 tag. When the ethernet frame arrives at your router interface with a VLAN tag the tag is stripped away before it is sent to the actual routing engine.You don't have to hav...

Member Since	‎12-31-2010 02:38 AM
Date Last Visited	‎09-25-2023 05:44 AM
Posts	26
Total Helpful Votes Received	12

User Statistics

User Activity

SMS for guest portal stopped working after upgrade to 2.2

Cisco ISE 2.0 Device administration, authentication compound conditions

C2960 12.2(55)SE7 Tacacs, high CPU

Configuring catalyst switches via DHCP option 66 boot file.

Cisco Prime NCS - How to get access point CDP neighbor report.

Thank you for your

Cisco Prime LMS 4.2 TFTP Directory...

Re: C2960 12.2(55)SE7 Tacacs, high CPU

Filter Syslog on Router

2 Vlans with 25 devices each with same network