Hi
Is FTDv 7.3.1 supported on VmWare version 8 update 2 ?
We run a FTDv HA setup, and just upgraded from VmWare version 7.x to version 8 update 2, after that our secondary FTDv seems to be fine from VmWare point of view, but in FTDv CLI all interface...
HiI have 2 frp 4140 running ASA code.We run multi-context with ~80 context and active/standby failover.We shut down the standby unit and moved it to another DC.During startup of the moved ASA we see some strange issues.My Active ASA goes directly fro...
HiI have a ASA running a very large config (22000 lines) and around 950 interfaces (via port-channel). It is running on a firepower 4140. The port-channel are two 10G interfaces and the failover link/state is running on its own 10G interface. Http re...
HiI have been testing always-on trusted network detection with a costumer running version 4.6.The currently get 4 dns servers from their internal dhcp servers.In the anyconnect profile i only put in the two of them and it worked - no problems.But whe...
Hihereby the "show failover history": 23:10:07 CET Feb 2 2022Active Cold Standby Failover state check23:10:09 CET Feb 2 2022Cold Standby Sync Config Failover state check23:37:54 CET Feb 2 2022Sync Config Sync File System Failover state check23:37:54 ...
Hi MarvinI did look at that document, but it doesn´t mention anything about "cold standby".I want to know what state that can get a ASA to go from "Active" to "Cold standby". Regards Henrik
Hi Alli found out that the firepower 2100 series can perform between 200 ~ 300 Mb pr. SA - so splitting up SA is the solution.Working as designed :-( /Henrik
