Cisco Community
English
Register
Great changes are coming to Cisco Community in July. LEARN MORE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
jlthorsell
‎08-18-2017

Beginner
Recent Badges
Awards
Recent Badges
See all
5 Replies
Stats
Member since ‎05-10-2012
12
Posts
0
Helpful
0
Solutions

SNMP

Created by in Switching
02-18-2014
02-18-2014
There is support for the SG200-50 and SNMP since March 2013 with version 1.3.0.59 Upgrade firmware a...

Site to Site VPN's 2 ISP network redundancy

Created by in VPN
01-11-2014
01-11-2014
Scenario:I have a network with 5 ASA 5505. One site is home office (main) and the others are remote ...

How to route traffic between interfaces on same router

Created by in Switching
07-05-2013
07-05-2013
ok I made it worse. I played around witht the routing table. Now I cannot ping devices accross the r...

How to route traffic between interfaces on same router

Created by in Switching
07-03-2013
07-03-2013
Here is my setup. I can get out to the internet on devices from both networks. I cannot communicate ...

How to route traffic between interfaces on same router

Created by in Switching
07-02-2013
07-02-2013
I have a cisco 1841 router with two fastethernet interfaces 0/0 and 0/1.Configured 0/0 as outside wi...

A SNMP OID alert has been recorded for SNMP OID ifInErrors.2. This value has exceeded 100 during 3 measurements.

Created by in Network Security
12-17-2012
12-17-2012
This happens about once a week. The error message means there are packets that are not routable comi...

how can I import the vlan.dat file to flash?

Created by in Network Management
11-29-2012
11-29-2012
I have copied the config and vlan.dat files via tftp to the computer and want to import them to a re...

Unable to change vlans on a cisco 2624

Created by in Switching
07-05-2012
07-05-2012
I have a switch that accepts the relevant commands to change the vlans, but does not make any change...

ASA5510 standy by failover

Created by in Network Security
05-16-2012
05-16-2012
The above commands work great aside for the commands for the mangement interface. I could not config...

ASA5510 standy by failover

Created by in Network Security
05-10-2012
05-10-2012
I am trying to make eth 0/3 the fail over link and using the management 0/0 for stateful info. I wan...

ASA5510 standy by failover

Created by in Network Security
05-10-2012
05-10-2012
Trying to set up a stateful failover with two. asa5510Here is what I have so far, tell me if this lo...
Public Statistics
Date Registered ‎05-10-2012 09:29 AM
Date Last Visited ‎08-18-2017 04:03 AM
Total Messages Posted 12
Helpful Votes Given To
See all >