You will need to install it manuallyhttp://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme81spc.htmhttps://supportforums.cisco.com/thread/2140439

Issue a 'dir nvram:'. This will tell you if the startup config is present in there. If you want a factory default configuration, it will be available in the software pack that you can download from cisco.com

If your PC is on the same subnet as the UC data vlan, you should be getting a DHCP IP address in the same subnet. If that is not working, assign a 192.168.10.x/24, with 192.168.10.1 as the default gateway. This should help you connect to 10.1.10.1 Yo...

Looks like your PC may not have a route to the 10.1.10.x network. Post the following - ipconfig (from the PC)show ip int brief | ex un (from the UC)

There is a PMF available to enable Call Waiting tone.https://supportforums.cisco.com/docs/DOC-16301