About mhooper82

mhooper82 · 12-06-2013

Hello!Just wondering if it's possible to configure a DMZ WLC in such a way that it will accept a join request from an OEAP on a none-management (outside) interface? (Port As you can see from the attached diagram I’m trying to use the DMZ WLC as a ph...

mhooper82 · 08-24-2018

Although it's been a good couple of years since I originally posted my issue I thought it would be a good idea to post the solution in case someone else gets stuck in the same situation. The attached diagram should explain the workaround that was put...

mhooper82 · 12-12-2013

Ok cool, thanks... As I don't have a spare WLC I went ahead and carried out the changes I mentioned above, and although I can now see the join request being processes (received/sent) by the WLC, the reply is never going to reach the OEAP as its sendi...

mhooper82 · 12-08-2013

Thanks for the reply Scott, so just to confirm, you’re saying if I wanted to keep the same physical design the only alternative solution would be to deploy a second WLC dedicated to OE?But if I keep the same design I would need to make the following ...

mhooper82 · 09-15-2013

What is the switch port configuration? Bear in mind that when you're using the AP as flexconnect the port needs to be configured as a trunk port, after that the WLC will see the avaliable VLANS.Sent from Cisco Technical Support Android App

Member Since	‎08-12-2012 04:12 PM
Date Last Visited	‎12-27-2018 03:57 AM
Posts	6

User Statistics

User Activity

OfficeExtend in a dual Firewalled DMZ - OEAP not registering

Re: OfficeExtend in a dual Firewalled DMZ - OEAP not registering

Re:OfficeExtend in a dual Firewalled DMZ - OEAP not registering

OfficeExtend in a dual Firewalled DMZ - OEAP not registering

Re:mode Flexconnect