About Plinio Brandao

Plinio Brandao · 07-01-2015

Hi everybody, I was doing some configurations using Nexus 7k with OSPF and I saw a point that I wasn't able to find a document with an answer for this. I know that OSPF in NX-OS has its peculiarities, but I trying to figure out the lack of the Routin...

Plinio Brandao · 03-14-2014

Hi Community,We are facing some problems about the BGP configuration and we'd like to know if you can help us with this issue.Description:We have a /23 prefix and we are trying to announce two /24 to the ISP.We know that for BGP announce a prefix it ...

Plinio Brandao · 10-23-2013

Hi Community,Maybe my question be simple and fully basic, but I'm confused about what I want to do.I verified that WAAS don't optimize no-TCP traffic, but I'd like to know if is possible to classifi an UDP traffic. In the capture from both WAAS I can...

Plinio Brandao · 09-09-2013

Hi Community,I'm facing some problems and I'd like to share with you to check if my understand is correct or not.I'm attaching the topology to help with the understanding.In normal situation, traffic is able to pass from the 5K to the 6500. However, ...

Plinio Brandao · 05-20-2013

Hi community,We are facing some problems with our CPI 1.3. The software suddenly stopped responding. We already tried to restart the service and the machine without success.The following message was shown when we tried to start NCS:gn827cb/admin# app...

Plinio Brandao · 07-06-2015

Hi, Just a feedback: I received this answer from another topic: From the book “Routing TCP/IP Volume 1”, 2nd Edition: The routing bit is not a part of the LSA itself; it is an internal maintenance bit used by IOS indicating that the route to the d...

Plinio Brandao · 03-14-2014

Jon,In this scenario we have just 4 host using this /23 (2 firewall and the 2 routers).On firewall, we have an outisde interface that is part of the /23 and one interface that is the inside (10.x.x.x).So, in this case, we will not have hosts on /23 (...

Plinio Brandao · 03-14-2014

Hi Jon,Yes, everything is working fine and as expected.I appreciate your attention.Thank you very much.

Plinio Brandao · 03-14-2014

Jon,I fix the problem using this config:ip route 190.25.2.0 255.255.255.0 Ethernet0/0ip route 190.25.3.0 255.255.255.0 Ethernet0/0 r1#sh ip bgp nei x.x.x.x advertised-routes BGP table version is 15, local router ID is 10.4.27.4Status codes: s suppre...

Plinio Brandao · 03-14-2014

Sure Joh,r1#sh ip route 190.25.2.0 255.255.254.0Routing entry for 190.25.2.0/23 Known via "connected", distance 0, metric 0 (connected, via interface) Advertised by bgp 65001 Routing Descriptor Blocks: * directly connected, via Ethernet0/0 R...

Member Since	‎07-08-2010 03:37 PM
Date Last Visited	‎05-15-2018 06:11 PM
Posts	73
Total Helpful Votes Received	10

User Statistics

User Activity

Routing Bit Set on LSA for NX-OS

BGP Announcing more specific routes (/23 in two /24)

Classifier UDP traffic in WAAS

L2 traffic not passing through vPC Peer Link

Cisco Prime Infrastructure has stopped to working

Hi,

Jon,In this scenario we have

Hi Jon,Yes, everything is

Jon,I fix the problem using

Sure Joh,r1#sh ip route 190