Hi guys.
This is the first time I am using this switch for qinq. The issue is because I need to encapsulate lacp over the tunnel but on the interface customer side, I have no command for that. The nx-os is able to encapsulate stp, vtp, but I didn't s...
Hi guys!
I'm migrating a L2TP/vpdn connection from Cisco Router 7200 IOS to ASR1006 IOS-XE 15.2(4)S3 and everything appears to be right, the authentication is passing ok, the end-point takes an ip address but the major issue, the icmp between end-po...
Hi guys!
Today I was almost crazy because I was changing one Policy (removing a condition in and replacing for a condition not in) and the ACS was freezing, after some minutes it gives a message that I clicked many times and back again. After that al...
Hi friends!
I'm trying to block users to use the command "configure terminal" using the ACS 5.3, but so far it's not working properly.
On the same Command-Set, if I put any other command (like reload, telnet) and choose Deny, it works fine, but to b...
Hi everyone.I'm implemeinting ISE and the customer has Cisco IP-Phone.I'd like to know if I need to put all the cisco phone mac address inside the ISE (making a MAB) or there is a way, for example creating an Authorization Profile that match Cisco IP...
Oh yeah.
After many years the solution is the same. I needed to NAT only the first octet and the tip above me worked perfect.
Be honest, I never payed attention about the option "network" under NAT config.
Thank you.
I've this problem too and it has been solved adding a prefix over a empty prefix-set that we've created for block some prefix faster, look the config below as an example.
The problem...#show rpl route-policy pfx_Peering-A detail prefix-set DENY_EBGP...
Dear NAGISWAREN2.
Nowadays I'm working with MetroEthernet Virtual Circuit Based, it means we've a MPLS Network and Virtual Circuits carrying services (l2vpn). So, we've just one customer using VPLS and running OSPF over the WAN using a /24 subnet. A...
