Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,We have a corp site (hub) and several spoke sites. We currently have two circuits at each site and have MPLS on one circuit and DMVPN as a backup on the other circuit. DMVPN uses EIGRP and MPLS uses BGP to advertise routes. The only EIGR...
All, I am having trouble with a WIC card that was recently installed. It is for an MPLS circuit. When it was added to the router, it came up showing as an embedded-service-engine. It isn't even close to something like that. Is there a way I can mak...
I am trying to establish a DMVPN tunnel from a new router that we setup in a remote location. We already have a hub and several other remote locations that work correctly. I can ping across to another remote site, but I do not see the correct address...
I have a question that I cannot find an answer to. I have a 2811 router at our Switzerland location that has 2 single WICS. When I do a sho ver it gives me the following information:2 FastEthernet interfaces2 Serial interfaces2 Channelized E1/PRI p...
That makes sense now. I see how that would work in a true hub and spoke environment. However, I believe I have conveyed our network topology incorrectly in the first post.Our MPLS network is fully meshed. The DMVPN is a hub and spoke, but if a spoke ...
If we redistribute the BGP routes into EIGRP, wouldn't EIGRP try to go over the same circuit that MPLS uses, or try to use the same gateway? The gateway for MPLS/BGP is the PE. The gateway for DMVPN/EIGRP is the other spoke's logical tunnel interface...
Paolo, Could you be a little more specific? I am just trying to get the WIC card recognized as a WIC card. Hod do I ignore the service engine? Once it is ignored, how can I use my WIC card?
I was able to establish the connection when I opened the inbound ACL on the TawianRTR wide open. We currently allow isakmp, esp, and gre between the two routers, which I thought would be enough to establish a connection, since the other routers use t...
Paolo abd Jose, Thank you for your responses. I am not having any issues with the device. .I was just curious why the configuration showed serail when in fact, there were no physical serial cards. The congiuration on this router has been around yea...
