Good day!I've been trying to refresh and practicing site to site configuration but i have some issues which i still cannot ping Host B from Host Abelow is my configuration from Router4 to R5-2, by the way in between R4 to R5-2 is connected thru OSPFR...
Good day!
I was designing our up coming office/project and we wanted a redundant links from router up to access layer switch. I have done from core to access switch using HSRP on Core switches. If possible we are planning to add 2 routers and bind ...
I have question if it is possible to block a particular group of extension number to call other extension number....
5XX not allowed to call 2xx, 3xx, 4xx
2xx, 3xx, 4xx not allowed to call 5xx
btw. I'm using 1 Cisco Call Manager 11.5 and telephon...
Hi
I am having the same issue we have checked the power cable and tested it and it it is okay but still I am having same issue with power supply 1
nvironmental alarms:system minor alarm on power-supply 1 power-output-fail (raised 1d00h ago)
backpl...
Hi
I noticed that I can telnet my router after like 1 day even SSH is not accepting my password.
% Authentication failed
% Authentication failed
% Authentication failed
I checked the router log got this message
780278: Apr 2 06:15:28.676: %AAA-...
@Chris IzattI have some few inquireies about your configuration.... are all R1, R2 and R3 have routing protocol running in between? If yes, are the inside network included in the routing?if No, there are missing configurations from your routers which...
Good day!I already found what is the mistake with my config which previously I am using the same NAT traffic to crypto map. I've created separate ACL for NAT only and deny the traffic from host A to Host B then create ACL for VPN traffic only pointin...
I have changed some configuration from the Access List from both routers and got this resultRouter4ip access-list extended NAT_LANpermit ip 10.10.10.0 0.0.0.255 20.20.20.0 0.0.0.255deny ip host 10.10.10.0 anyR5ip access-list extended HQ_OFFICEpermit ...
Hi RedThank you for your inputs. anyway this is my plan regarding our new office from core to access switch already done and working but from router side still not yet
