About Greg Dickinson

Greg Dickinson · 10-14-2020

I've read the docs and searched around, and I can't get a definite answer to a question presented to me. If we have the AMP policy enabled, and have it configured to send "Pending Analysis" messages to the quarantine - will the messages be released ...

Greg Dickinson · 07-19-2019

I have a question about host licensing in CWMS, that's a little unclear from the docs. Our users are synced with CUCM, and most of them are marked "inactive" as most users don't get hosting access. Of the users that are marked "Active", most of the...

Greg Dickinson · 11-09-2018

I have a Win 10 Pro laptop that's connecting to my ASA, and the OnConnect script doesn't seem to launch. I can look through the event log and see where it downloads the script (and I can run that script at the command prompt, and get the expected re...

Greg Dickinson · 02-09-2018

I will readily admit I'm still learning the platform I inherited. I have a Defense Center version 5.4.1.3 virtual appliance, and an ASA 5515-X running sensor code 5.4.0 that I just recently reimaged to get it working properly again: Sourcefire Li...

Greg Dickinson · 11-01-2017

I have a task to configure our ESA to prevent our network scanners from sending email outside our local domain. Is there an easy way to specify a list of IP addresses (or hostnames), and then only allow those IPs to send email to [something]@localdo...

Greg Dickinson · 12-14-2020

I opened a TAC case on this same issue and it was closed, they basically said "A workaround was provided". Like you, I don't have the manpower to contact hundreds of users to manually upgrade their clients. I've reopened the TAC case and involved m...

Greg Dickinson · 10-14-2020

OK, so if the verdict is received before the 30 minute timeout, then the message is released immediately, otherwise it is released after 30 minutes regardless. Thanks

Greg Dickinson · 11-09-2018

Yes, I tried both a .BAT and a .CMD file and they both downloaded to that location. The script is very simple, it just restarts a service that requires network connectivity to an on-net server at startup, and never retries if it fails. @echo off e...

Greg Dickinson · 12-26-2017

Any news on when the maintenance release will be available?

Greg Dickinson · 12-08-2017

Is there any update on this? I notice that the 10.5 version has been pulled from download, and there's now an 11.0 version that is in "Limited Deployment". I still don't have any patches from the WSA GUI.

Member Since	‎02-24-2010 09:46 AM
Date Last Visited	‎12-23-2020 04:43 AM
Posts	47
Total Helpful Votes Received	5

User Statistics

User Activity

ESA file analysis (AMP)

CWMS Licensing question

AnyConnect OnConnect script not launching

ASA Sensor upgrade fails

Block specific IPs from sending outside local domain

Re: CSCvr85747 - Unable to update the Cisco desktop application and getting an error - 1

Re: ESA file analysis (AMP)

Re: AnyConnect OnConnect script not launching

Re: Periodic reports failed

Re: Periodic reports failed