I'm a WISP, I have a 2851 router at our head-end that has a 4 port EHWIC in one of it's slots with our wireless backup link, bandwidth manger's management interface, and power monitoring device plugging into it.  A few hours ago I our network monitor...

I work for a small ISP that has two fiber connections from Level3, both fibers plug into a single Cisco 2951.  The two fibers are both limited to 500 Mbps, currently we are set up to use just one fiber at a time.  Our owner would like to change that ...

I just got a 2951 router the other day that came with a 4GB flash card.  I can copy to and from the card, but I can't seem to set the system to boot from it.  Everytime I issue the command "boot config flash0:/startup-config" in the from the global c...

Not sure if this is the appropriate place to post this discussion, so I appologize in advance if it is not.  Is there any possible way to make the line passwords (con 0, aux 0, and vty 0 4) and OSPF message-digest-key type 5?  Either directly or by t...