Hi Jens-Peter,I would try disabling smartports and green ethernet on the SG200 switches. Then you will need to hardcode each of the ports to have the necessary settings. Often times when a reboot is required to restore functionality smartports is t...
Hi rod3,Typically SSH/Telnet is disabled by default on devices. In order to activate it you will need to go through the WEB GUI to Security > TCP/UDP Services and check the boxes that say SSH or Telnet then click apply.Then using a Terminal program ...
Hi Robert,I don't think the SPA901 is officially supported on the UC500. However you may try a configuration like the following:https://supportforums.cisco.com/message/1128844#1128844As for the Voice VLAN, I will look at page 99 of the admin guide:h...
Hi Amit,I believe you may have the wrong forum as this is a SMB forum.Also, if this issue is critical you may consider opening a case with TAC.-Trent Good ** Please rate useful posts! **
Hi Luis,You can configure a dial-peer mapped to a translation profile mapped to a translation rule. Something like the following (this is bare bones, you will probably need more)voice translation-rule 1112rule 1 /^0\(........\)/ /10787\1/voice trans...
