I seem to be having a weird issue where I am able to assign an ip address from a local pool if it is part of a different subnet than the inside interface. But if I try to create a pool where i use a portion of the subnet that is on the same subnet as...

Hello Fellow Net Pro'sI am currently working on a design that includes an extranet/vendor dmz network protected by a couple of ASA 5520's running ospf.The inside interface of the router is part of area 0 while the dmz interface is part of area 20.Thi...

Okay guys so I'm sort of in a predicament. I currently have a set of firewalls in active standby configuration running an ospf process injecting a default route into the rest of my network.I noticed when i was testing the failover that the asa's do n...

I have two ASA 5520's setup in an active standby configuration. Each pix is configured with a inside and outside interface. I am also using the other two interfaces for the failover, and stateful pair. These firewall's are directly plugged into each ...

Fellow Net Pro'sI am currently working on a new data center design that will be housed at a co-lo facility.What I was wondering is if I assigned a loopback address to every device that I have on my diagram. Does it make sense to use it as the router ...