Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning,
I am trying to find out if there is way to fail back to my primary ISP circuit without unplugging the secondary circuit?
Is there a command for this on the primary or secondary router?
Two circuits, two ISP's. 3945 routers for both. ...
this is probably an easy one to solve but at the moment it is not getting past my brain...I have a P2P network set up to another building. that building is being collapsed and I want to bring that subnet back to my core switch. I have two stacked co...
I am trying to configure netflows. If adding the command ip route-cache to the interface that is configured with BGP routing will that cause problems/disruptions?Also, the command should be ip route-cache flow as far as I know but the CLI will only ...
Hello, I am having a beat my head against the wall moment. Trying to put in a access-list statement for an external IP to a DMZ ip address allowing only 80 and 443. this is the statement -access-list outside_access_in line 4 extended permit tcp hos...
This is a 2 part question...How many split tunnel VPN's can a ASA5510 handle?What are the necessary commands/steps to setting one up?I have not done this in a while and I want to make I don't mess it up.thanks
Hey guys, sorry for the delay in update but I had missed the ip helper after the SVI when reconfiguring everything. All is good now. thanks again for all the help!
thanks at one point this was working great then something happened and some people are unable to get a DHCP address. I have removed everything relating to an int vlan160 in any other switch than the main core. All desktop ports are set to vlan 160...
hey guys, is there anything on that config that would limit the bandwidth to that vlan?I am not getting full throughput on that vlan and they are getting crushed. thanks
