Roomkit EQRoomOS 11.9.3.1Configuration / H323 ->CallSetup Mode: DirectConfiguration / NetworkServices-> H323 Mode: On
If I try IP Direct Calㅣ, there is a problem.Dial command failed. Error: Unknown errorRoomkey Pro fixed the issue with a factory rese...
I thought (Dialing by IP Address) was possible in Cisco Expressway Administrator Guide X12.5 guide. But I can't call(ip address) from SIP endpoint to SIP endpoint the error below appears..Is there a way to solve it?
During CMS Meetings, a message appears when a participant comes in or leaves. (use Roomkit video out)Can I remove or hide messages with CMS settings? Thanks.Regard.
L-KITPRO-MS (embedded multipoint)If the roomkit pro registered with webex ,but we can't do multisites conference using L-KITPRO-MS (embedded multipoint license) Method is unknown. I'd like to know how. Thank you Regards,
I solved "Dial command failed" Error with TAC's help
TAC advice is " Setting admin password " in this RoomOS version (and Register call)
After setting admin Password, this problem was preprectly solved.
Good luck, Regard
I solved "Dial command failed" Error with TAC's help
TAC advice is " Setting admin password " in this RoomOS version
After setting admin Password, this problem was solved.
Good luck, Regard
I have the same problem with IP Direct calls. (Roomkit EQ)Roomki Pro solved the problem by factory resetting after downgrading to the RoomOS10 version. I have been trying to fix the Room EQ issue, but Cisco have been not providing RoomOS 10 for Roomk...
Hi, I have the same question. (Room EQ support Full USB-C)
https://help.webex.com/en-us/article/ney3qxe/Call-from-laptop-using-your-Cisco-device-as-a-web-camera#Cisco_Reference.dita_8968f4af-f365-4ba8-b11a-729d90b4c9e6
But Room EQ is not mentioned in...