Hello All,I am new to the new Cisco IOS XE platform and when I try to add a static NAT entry for telnet port 23 I get an error stating "%Port 23 is being used by system". Is there a way to make port 23 available and disable it on the system?

Hello Everyone,          Looking at this configuration would it be correct to say that the 50.50.50.17 subnet (Subinterface 50) would not be translated due to that it does not have the "ip nat enable" command when it exits fa0/1 (eventhough ip nat en...

        What are the possibilites that a router's snmp would just stop working?I have a 2811 router that was responding fine to my network management software. The router is NOT within my local network. So we had a nasty power outage where my monitor...