GuoPatrick02

I can see why Cisco made per-destination the default option for load-sharing. Thanks for adding that...

THANK YOU ALAIN!I needed to do the "ip load-sharing per-packet" command on each serial interface sin...

The link from my far end router to the edge router is a fastethernet link. If each T1 link is load b...

On one of my previous experiments, I did a test where my computer was behind a router that's connect...

OHH lol I thought you were talkin about old commands too. Thanks for the answers

Ehh I'm kinda confused. Do you know that there's some differences or is that what you think? Somebod...

Ehh I was lookin more towards if "I could use 15.1 IOS to study for the CCIE lab exam"

Hey, I heard that IOS 15 is basically 12 with more features. Are all the commands still the same or ...

Yeah...I found the problem. I need the version 2, version 1 doesn't work on these routers

Oh wow, it says for both slots "WIC module not supported/disabled in this slot" Any way to fix this?...

Today I got a pack of 7 Cisco T1 DSU/CSU WAN Interface Card (WIC-1DSU-T1-V2). I installed 6 of them ...