Hiya doin' folks, I'm currently having some trouble with EPC running on IOS XE WS-C3650-48PD 16.6.5.I can configure it just fine and the output of "show monitor capture mycap" and / or "show monitor capture mycap parameter" lokks good, just as it sh...
Hello all,in my LMS 4.1 I have 10 2960S 48 FPS-L switches, which have originally been added into "Cisco Catalyst 2960 Stack" LMS group.After I try to change identity of those switches in "Add/Import/Manage Devices" and move them into correct device g...
Hi all,after reconfiguring my LMS 4.1 from snmp v2 to snmp v3 the endhost aren't reachable anymore. Before configuring the snmp v3 I have purged the endhost database in order to repopulate it. After the jobs run no endhost could be added to repositor...
Hi Modestas, sorry for the late reply. No, I wasn't able to solve this so I just let it as it is. no packet capture on devices running lan base. Cheers
Thank you Mark for your swift replies.Than I'll just leave it as it is, as I already invested too much time in troubleshooting.Will try on the next reelases again when we update the switches.Gonna mark your answer as solution in case anyone else has ...
Thank you for your reply. I'm aware of the document, but the issue is that the buffer is empty. So I'm unable to check traffic directly on the switch.But the export command is there, in order to export buffer content into pcap file and it works as we...
Thank you very much. I have already applied this to one switch, unfortunatelly the switch needs to be restarted what is impossible at the moment.I will post the results as soon as I'm able to reload the devices.Best regards
I just moved the deice into 2950 container and the same issue occured. The 2950 container gone and device moved back into 2960-stack container.Here the sh vers:SW_MUC2_06#sh versCisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 15.0...
