About Max Antonenko

Max Antonenko · 07-09-2013

Hello.At SCE8000 error occurs:Interrupt Received from: NalaDPT[0].Tx[0].CTX_ISR.ECCSingleErrorInt - description: RLDRAM ECC single bit error interrupt - count: 1Interrupt Received from: NalaDPT[0].Tx[0].CTX_ISR.ECCSingleErrorInt - description: RL...

Max Antonenko · 09-19-2016

Hi Xander, Is it possible to remove previously applied ACL to the subscriber interface via CoA? For an example need to remove inacl from: RP/0/RSP0/CPU0:BNG#show access-lists ipv4 interface Bundle-Ether100.100.ip71Input ACL (common): N/A (interface):...

Max Antonenko · 07-09-2015

HiMaybe I contact the TAC on this issue?Thanks.

Max Antonenko · 07-06-2015

Hi The following configuration is not working (subscriber 89.x.x.18 can't ping gw 89.x.x.17): interface Bundle-Ether100.2301 ipv4 point-to-point ipv4 unnumbered Loopback2301 service-policy type control subscriber STATIC_IPSUB encapsulation dot1q 2301...

Max Antonenko · 07-03-2015

I have not found where in the dynamic template I can specify ip address of the interface. When I assign ip address using the radius then the session always stay in CD state and subscriber does not work (Framed-IP-Address=89.x.x.17, Framed-IP-Netmask=...

Max Antonenko · 07-03-2015

I made the following settings: class-map type control subscriber match-any ANY-PKT match source-address ipv4 0.0.0.0 0.0.0.0 end-class-map dynamic-template type ipsubscriber STATIC_IPSUB accounting aaa list default type session periodic-interval 15 ...

Member Since	‎06-26-2013 10:06 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	2

User Statistics

User Activity

SCE8000

Hi Xander,

HiMaybe I contact the TAC on

Hi The following

I have not found where in the

I made the following settings