About James Reynolds

James Reynolds · 10-30-2020

I am confused about this bug report. It is not clear which devices are affected by this. At the symptoms section it says ISR4000, ASR920, ASR1000 and cBR-8 and no mention of versions. In the details section it mentions a single version 15.5(2)S and t...

James Reynolds · 06-07-2018

I have witnessed this issue and it appears to be caused by HSRP i.e. when an HSRP hello packet is received from a peer

James Reynolds · 06-20-2017

You need to make sure that each PE that is advertising the prefix has a unique RD. You then also have to make sure that the RRs are enabled for multipath. This will mean that the RRs will pass both routes to PE3 so that it can either select the singl...

James Reynolds · 05-22-2017

"ip source-route" does NOT mean that you are routing by the source address. The clue is in the name "source-route" as per earlier comments (13 YEARS AGO) means that the routing is determined by the source DEVICE i.e. the sender of the packet. It has ...

James Reynolds · 07-09-2013

Thanks joefharr - I was looking for this too. I came across it on another website but couldn't locate it on CCO :-S Much appreciated.

Member Since	‎07-09-2013 01:51 AM
Date Last Visited	‎02-13-2024 06:20 AM
Posts	5
Total Helpful Votes Received	21

User Statistics

User Activity

CSCuy11815 - Cisco IOS XE ROM Monitor Software Vulnerability

CSCts41032 - percentSYS-2-NOBLOCK suspend with blocking disabled tracebacks.

You need to make sure that

"ip source-route" does NOT

Cisco Virtual Tunnel Interface (VTI) Design Guide