About Jaca

Jaca · 06-13-2019

Trying to create a TCL script to run a traceroute from a specific IP address on Cisco 3750v2; Software Version: 12.2(55)SE8; Software Image: C3750-IPBASEK9-M I'd like to be able to run the script to traceroute to a certain IP outside of the network f...

Jaca · 06-16-2016

Gateway is configured as H.323. Call Manager version 11. Cisco Phone 6941 active load SIP69xx.9-4-1-3SR2 Would like to have only the number show up as caller ID from external callers and not the name. FXO Port Configuration: voice-port 0/1/1 trunk-...

Jaca · 08-12-2019

You'll need to post more information to get a relevant answer. Sounds like the call is terminating properly, but CFNA is not configured correctly. Debug your dial peers and see if they are matching properly. Clean up and post your configs of the VG w...

Jaca · 06-13-2019

Thanks for the reply Hector.Switch#traceroute 1.1.1.1 source 2.2.2.2^% Invalid input detected at '^' marker. The switch does not support that command and now explains the error presented with the TCL script I was using.Any recommendations for a bette...

Jaca · 05-14-2018

There isn't much from CDR that will tell you if a fax was successful other than call duration and disconnect cause code. You'd need to run debugs on the gateway it's traversing to get a better idea. I've had faxes sent out and state successful from...

Jaca · 05-11-2018

I agree with all other posters here. You are in uncharted territory and it can take years to get to a point where you'll feel comfortable in a CM environment. A CCNA in R&S will get you to the point of design and terminology for QoS, subnetting and 8...

Jaca · 04-22-2018

Try adding to the matched VoIP dial peer: progress_ind setup enable 3 and progress_ind alert enable 8 to the POTS dial peer. This may not solve your issue, but if it does or you do end up finding a solution test call transfers to make sure ...

Member Since	‎06-10-2013 10:17 AM
Date Last Visited	‎08-15-2019 11:36 PM
Posts	20
Total Helpful Votes Received	20

User Statistics

User Activity

TCL script for traceroute with source IP address - 3750v2

External CLID shows name only on Cisco Phones - FXO ports

Re: i started to use a cube router when a outside call comes in and not answered it goes to unity but not the uses Voice mail

Re: TCL script for traceroute with source IP address - 3750v2

Re: CDR Report signs for successful fax

Re: Frustation in Collaboration Job, Need Your Advice!

Re: CME no ringback tone for outgoing calls over SIP Trunk