i have two ISR routers with VIC2-4FXO and running 15.1(4)M5 First routers FXO port gives fast busy when i send out call to PBX while the 2nd router's FXO port works fine for outbound call to PBX Both routers FXO port are having same configuration. ...
IOS 15.1(4)M5I have a H323/SIP voice gateway at remote site communicating with SME 8.6. The gateway is integrated with PBX which are very old so i have done integration with FXS [inbound from PBX] and FXO [calls to PBX]I have the following dial peers...
I have done an integration between VIC3-4FXS/DID card with Meril Legend DID Card. I see alarms when the DID port of Legend PBX is connected to the FXS port. I used Loopstart for signaling while PBX used Immediate start signaling on DID. Provided the ...
Im working on a Cisco router PBX integration using FXS card [dont ask me why I didnt use FXO. Im forced to use FXS card] , So the integration will be done with Avaya G3si which has 800-DID card and some CO trunk card. I writing the...
Thanks once again.. at the moment the EU user jabber collab-edge discovery is hitting USA EXP-E, lt me try adding the Eu CUCM servers in EXP-C of USA. its in the same domain. will keep you posted
i think i did messed up reading the MRA guide at 4 am :-)
So let me understand this correctly.. in USA EXP-C i will need to add EU CUCM under Unifed Communications Server. the zone will be only one UC Zone but i can add multiple UC servers into EXp-...
Hi jaime
I just read the MRA guide and it says "You should configure only one Unified Communications traversal zone per Expressway"
so my question isnt valid in previous post.. however i was wondering , proxy registration request coming in through ...
Thanks for the clarity Jaime, i have a doubt on this below statement
"The difference is that for MRA, you'll also need to add the UC servers in EXP-C so the zone between EXP-C and the servers is created for the registration to work."
For USA , i have...
