About Mohammed Yaseen Ansari

Mohammed Yaseen Ansari · 05-03-2015

Dear Team,I have an issue regarding Remote VPN. Users would like to connect to one of our server which is in another country using Existing Remote VPN. Server is reachable via MPLS. Remote VPN configured on Cisco ASA 5505.What are all changes require...

Mohammed Yaseen Ansari · 04-04-2015

Hi All,I have been facing on one of my Router WAN MPLS Link Connected Interface, FE. In logs, I am getting below logs continuously and have done below troubleshooting.Router Model - Cisco 1841, IOS (C1841-ADVIPSERVICESK9-M), Version 12.4(19b).Interfa...

Mohammed Yaseen Ansari · 10-03-2013

Dear Team,We all know about redundancy being the best part to keep your network active and health all the time. My concern is to get more and more details about how we can get redundancy between two switches or two routers using L2 or L3 protocols/te...

Mohammed Yaseen Ansari · 04-18-2013

Dear Team,Can anybody tell me where I can get the Cisco Document ID details so that I can surf them categorically?Like we have Document ID: 23563 - For Unicast Flooding in Switched Campus NetworksI wanted to know each Document ID details or may be in...

Mohammed Yaseen Ansari · 02-22-2013

Hi,I have Cisco AIR-SAP2602I-E-K9 Implemented and connected to PoE Switch but the users trying to conenct this AP don't get IP Address.Dot11Radio0 is up and Dot11Radio1 is down. SSID are created fine.Subinterfaces for Agilec0nnect and Agilec0nnect1 i...

Mohammed Yaseen Ansari · 04-12-2015

Dear Leo and Joseph,Thanks for always sharing your great experience and suggestion here to me and all...There is definitely a media translation device between CE and PE.There was wrong input provided by ISP, they earlier had auto-auto their end and a...

Mohammed Yaseen Ansari · 04-11-2015

Yes Joseph, it is on Fiber at their ISP end.

Mohammed Yaseen Ansari · 04-07-2015

100/full on both end is not working.Attached ISP end interface output. Checking with ISP for Device and IOS details. After these details, we will plan for auto-auto on both end.My link is of 2Mbps, can we get it cross-checked with this interface outp...

Mohammed Yaseen Ansari · 04-06-2015

Hi Joseph,Thanks for your reply!I tried cross-over cable but no luck! Still cross-over is connected and observing same issue (late collision and half-duplex on Interface end).While trying changing interface at my end to 100/Full, I am losing the conn...

Mohammed Yaseen Ansari · 04-06-2015

Thanks for making me understand on Output Drops!Ok, we are seeing duplex mismatch and I am checking with my ISP to auto-negotiate at their end.Wont there be any issue keeping auto-auto at both ends, ISP and ours? Why I am seeing here Late Collisions ...

Member Since	‎02-22-2012 03:12 AM
Date Last Visited	‎10-09-2017 12:51 PM
Posts	36

User Statistics

User Activity

Remote VPN to connect (other locations) Internal Servers which are hosted over MPLS

Late Collision on WAN Link Interface

Different way to create redundancy between two Switches (at Layer2 and Layer3) or two Routers

Cisco Document ID details

Cisco AIR-SAP2602I-E-K9 Installed but Users don't get IPs

Dear Leo and Joseph,Thanks

Yes Joseph, it is on Fiber at

100/full on both end is not

Hi Joseph,Thanks for your

Thanks for making me