vincehgov
Level 1
Level 1
Member since ‎12-07-2009
‎08-18-2017

User Statistics

  • 155 Posts
  • 2 Solutions
  • 40 Helpful votes Given
  • 19 Helpful votes Received
Recent Badges
CCP Member
1 Accepted Solution
10 Helpful Vote
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

I've looked through the Cisco config guides for setting up Config sync and have successfully used it to configure dual-homed FEX's ports.Is there anything I should be aware of that can cause issues?I enabled config sync on an existing pair of 5Ks.  I...
I'm running an ASR1001 with IOS-XE version 15.1(3)S6.I don't seem to be able to apply a policy-map to a tunnel interface that running in "tunnel mode ipsec ipv4".  The router gives me the error: Error: NBAR is not supported on Tunnel227.   When I try...
I have configured the G0 interface with an ip address and placed it in the Mgmt-intf VRF.  I can ping the management ip address accross my WAN but I cannot SSH to it.  I can, however, SSH into any of the transit interfaces.Thank you in advance for an...
On working on a FWSM using ASDM 5.0F.I was trying to add another host to one of my object groups but was getting the error "this operation will result in some security rules getting nullified. Please review your translation/security rules before retr...
I'm having a strange issue.  I'm running a 3560 8 port switch with c3560-ipbasek9-mz.122-58.SE2.bin.Here is the relevant config:interface Vlan140 ip address 172.20.40.18 255.255.255.0ip route 0.0.0.0 0.0.0.0 172.20.40.1aaa new-modelaaa group server r...
Community Statistics
Member Since ‎12-07-2009 05:04 PM
Date Last Visited ‎08-18-2017 04:03 AM
Posts 155
Total Helpful Votes Received 19