Hi friends,I'm configuring Cisco 2911 PTZ camera (By Pelco), but I doubt one configuration:Is it possible to configure this model of camera is operating with a routine of always record movement at 180º degrees?Example: Set point A and B, the camera r...
Dear friends,Can view a solution to this case?Scenario:CUCM 7.1.5.20000UCCX 7.0.5_SR5Agent_1Agent_2Queue_AQueue_BAgent_1 meet Queue_A and Queue_B, while Agent_2 meet only Queue_B.Queue_A works from 7:00am until 6:00pm. Queue_B works from 12:00pm unti...
Hi All,I'm trying to transfer an existing image of Phone Designer Phone to a 7945G.However after a few moments later the message is: ''A communications failure occurred''Below is the Log Problem Report:2010-01-07 16:11:01,828 [1] INFO - UpdateImageV...
I am with problems in the Cisco Desktop Supervisor version 4.5.7.4 making the rounds IPCC 3.5 The statistics of the attendance lines appear with the data agents zero. They appear only the names and status. Who faced this type of problem?
Olá Pedro Lima!
Li todo o histórico desta discussão, mas não conclui se funcionou a integração SIP com a Sonetel.
Pode me passar um feedback se funcionou? Se sim, qual foi a configuração final do router?
Desde já, muito obrigado!
Alan
Hi Michael,The URL Authentication parameter is correct: http://10.120.108.110:8080/ccmcip/authenticate.jspAlso this EndUser with correct permission, device associated and Phone Personalization Enable.Is there any other parameters needed change ?Thank...
