Hi guys, I have come across a peculiar scenario in which my Campus Edge router is learning routes from my MPLS provider through an eBGP neighbourship. Most of these routes can only be learnt through the provider router and no where else. The funny t...
Hi All,
My query is, how is it possible to block calls to a specific outgoing number ( in my case it is "2519 2519" ) , depending on who is initiating the call.
I have three different branch offices with different PRI ranges a each office .
...
Hi ,
I have a strange situation.
I have a few routers in an iBGP domain which are direct neighbors with each other.
Two of those routers ( RT2 and RT6 ) also learn some routers through an eBGP peer on the WAN link .
These eBGP learnt routes ar...
Hi All,
I am migrating one of my routers from 3800 series to the new 4351 series .
I will use this router to terminate IPSEC tunnels, and want to disable MOP protocol on the local interfaces . For some reason the new 4351 has no such command call...
Hi all,
We have a 3845 Router running an Adv-enterprise service image on our premises.
I was thinking of installing a security license on it and upgrade the IOS ( if necessary ) .
The purpose is to use is as temporary GRE router for my back up site ...
Hi,Thanks a lot @Giuseppe Larosa . I did not understand your first point well . ( my knowledge base in MPLS/service-provider stuff is limited ). But you are right in pointing out that the prefix is being learnt "only from one source" - and it also be...
Hi All, Thanks for your replies.Posting the output for show ip bgp 1.6.36.32 below. INTNE-S-RT10#show ip bgp 1.6.36.32BGP routing table entry for 1.6.36.32/32, version 56303Paths: (1 available, best #1, table default)Advertised to update-groups:2Refr...
Hi Thanks for the reply. 1.6.36.32/32 is a network advertised from our US office. ( It is just an example in this case - there are more than 6000 routes with the same behaviour) The bgp configuration is as follows. router bgp 65210bgp router-id 10.23...
Thanks a lot Chris :)Is there a document for me to understand how to do this ? As i said i am pretty new to CUCM . I assume i have to go to Call Routing > Route pattern .I can see many pre-configured rules over there, like the wildcards configured ( ...