vanbergehenegouwen
Beginner
Beginner
Member since ‎10-16-2006
‎09-05-2022

User Statistics

  • 18 Posts
  • 0 Solutions
  • 4 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

Hi Randy,We have a situation with 20 4410N's They are connected through a 2960 switch. They runned for about a year with no problems. We use the WiFi system with 10 cisco wireless ip phones, several workstations (5-10) and a few mobile devices.Three ...
The "?" button's on all phones result in a host not found error.According to TAC support this is by design, in CME. This button only is working in CCM..I think this is rather crazy, because now every time a user will click this button and receive the...
Hi,I have a CME system with one 7961+7914 module, on the 7914 i try to configure the button's in such way that they directly connect to an FXO port.This actually works with the trunk command on a ephone-dn, it will give a dial tone and users are able...
Is it possible to have some sort of QoS on both sides of a VPN tunnel when the speed at the endpoint is unknown. In other words is it possible to have QoS bandwidth parameters to be automatically detected/adapted to the actual bandwidth?
Hey,Is someone able to help me out a bit on this one?I'm trying to design a site-to-site VPN setup, but my knowledge of VPN's in relation to Cisco equipment limit me a bit.What I would like to create is a link between two sites (one mobile Cisco rout...
Community Statistics
Member Since ‎10-16-2006 10:59 PM
Date Last Visited ‎09-05-2022 07:55 AM
Posts 18
Helpful Votes Given To