I'm trying to determine real-world limits on TCAM for (mainly IPv4) ACE's in the ASR 9901 and/or the 9904 with the A9K-4X100GE-SE line card from people that have experience with them.. My Cisco team is having difficulty getting to hard specificatio...
I was working to upgrade a 4-switch 3850 stack from cat3k_caa-universalk9.SPA.03.03.01.SE.150-1.EZ1.bin (Install mode) to 03.07.04, and it failed to copy to one of the switches because it had an additional image still on that one.
I cleared that o...
Hello,We'll be adding a DS-3 connection soon with a "standard" service charge for 10mg, but with the capacity to climb above that for an additional charge. The service provider is installing a router, so the service will be handed to us on Ethernet....
I have a 3550 connected to a 3Com switch used to offload non-PoE devices and save ports on the 3550. Connected to the 3Com are 2 ATA 186s. The ATA's only run at half-duplex, and are working fine, but as the 3Com attaches to the 3550 on full-duplex,...
I'm attempting to import phones and users with the BAT version 5.0(2) and CCM 4.0. The file is validated fine, but when I do the insert, the browser returns the error dialog:Error Number: -2146828279Description: Subscript out of rangeThe users then ...
@smilstea Thanks again. No worries on that distinction regarding the "hw-module profile" command. Just so I'm 100% clear then, both the 9901 and the modular Tomahawk -SE cards are fixed at a max of 96k ODS2 TCAM entries, resulting in a real-world IP...
@smilstea , thank you for the additional information. That was very helpful. One final inquiry if I may: Will the 9901 able to utilize the "'hw-module profile tcam tcam-part-70-30" configuration, and if so would that further increase the TCAM block...
Thank you @smilstea ! Could I follow up on a few points:What card and what type of card is that output representative of? What I'm trying to get to is how close is this example output to either the 9901 or the 4x100GE-SE Line Card? The first example ...
I was originally hoping to set the switches to boot in bundle mode from the newer code, and get this done in two reboots, but the switch that had failed the original copy wouldn't report additional free space on the flash, even after deleting other f...
Yeah...
I'm considering setting it to boot from the .bin during my maintenance window, hoping that gets it online for sure, then transition it back to install mode. I'm just not excited about the 2+ hour drive in a rush I'm looking at if that does...
